Service Bulletin
B18-073
December 20, 2018
Version 1
Fuel Fill Door Rear Edge Does Not Line Up
AFFECTED VEHICLES
| Year | Model | Trim | VIN Range |
| 2017-19 | MDX | ALL | VINs that start with 5J8YD |
| 2017-19 | MDX Sport Hybrid | ALL | VINs that start with 5J8YD |
SYMPTOM
The fuel fill door rear edge does not line up properly when closed.
NOTE
This service bulletin only applies to alignment issues at the rear of the fuel fill door. If your vehicle has alignment issues elsewhere, this bulletin does not apply.
POSSIBLE CAUSE
The fuel fill door latching mechanism does not line up properly.
CORRECTIVE ACTION
Replace the fuel filler lid cover.
PARTS INFORMATION
| Part Name | Part Number | Quantity |
| Label (Fuel Filler Caution [Unleaded Fuel Only]) | 17669-R9S-A10 | 1 |
| Label (Capless Information) | 17669-TG7-A01 | 1 |
| Fuel Filler Lid | 74481-TZ5-A02 | 1 |
WARRANTY CLAIM INFORMATION
The normal warranty applies.
| Operation Number | Description | Flat Rate Time | Defect Code | Symptom Code | Template ID | Failed Part Number |
| 8491D4 | Replace the fuel filler lid and labels. | 0.3 hr | 06201 | 07303 | B18073A | 74481-TZ5-A02 |
Skill Level: Repair Technician
REPAIR PROCEDURE
- Check if the rear of the fuel filler door sticks out more than 1 mm.
- If it does, go to step 2.
- If it does not, this bulletin does not apply. Continue with normal troubleshooting.
- Apply the fuel filler caution labels to the new fuel filler lid cover as shown. Make sure the new lid is clean and grease-free, especially on the surfaces where the labels will be applied.
P/N 17669-TG7-A01 (Capless Information)
P/N 17669-R9S-A10 (Fuel Filler Caution [Unleaded Fuel Only])
- Remove the original fuel filler lid cover.
3.1. Lift the fuel filler lid locking tab.
NOTE
The original fuel filler lid cover may be a flat type like the one shown below, or it may be a hooded type like the one shown in step 2. All the replacement lids will be the hooded type.
3.2. Slide the lid towards the fuel fill door hinge.
3.3. Slide the lid until the four tabs disengage from the slots in the fuel fill door.
- Installation of the new fuel filler lid is the reverse of removal. Verify all the tabs are engaged, and slide the lid away from the fuel fill door hinge until it clicks. This indicates the fuel filler lid cover is secured and correctly installed.
- Make sure the fuel fill door closes and latches without contact or interference from the mis-fuel inhibit device and surrounding area.
- Make sure the fuel fill door release works correctly when using the fuel fill door release button. If the fuel fill door still sticks out more than 1 mm, check the fuel filler adapter for broken clips or mis-installation. If the adapter is OK, do normal troubleshooting.
END
B18-073
December 20, 2018
Version 1
- Buyer's Note: This plastic funnels for automotive use OEM#8U5A-17B068-EB 1782177 1833948 2050651, measures 6.85 x 1.65 x 1.65 inches, it is important to verify your vehicle model and OEM number before purchasing to avoid compatibility issues
- Compatible Models: Compatible with Lincoln 2009-2014 Navigator, 2010-2018 MKT, 2010-2018 MKZ, 2015-2018 MKC, 2016-2018 MKX, compatible with Mercury 2008-2010 Mountaineer, 2009-2011 Mariner, 2009-2011 Mariner Hybrid, 2010-2011 Milan Hybrid
- Applicable Models: Compatible with Ford 2009-2017 Flex, 2009-2016 F150, 2009-2018 Escape, 2010-2017 Taurus, 2010-2017 Mustang, 2010-2015 Expedition, 2010-2016 Fusion, 2010-2014 Explorer, to learn more about the models, please refer to the detail page
- Leak-Proof and Portable Design: The car funnel has a side clip that keeps it from falling out, so you don't have to worry about spills when refuelling for a clean experience. Its compact size makes it easy to store, making it a must-have tool for trip
- Premium Material: Crafted from PVC, the fuel funnel is built to withstand wear and tear, keeping it wonโt crack or break during use. Its robust construction makes it a reliable tool for your automotive fueling needs, whether at journey or on the road
- High Quality: This capless gas tank fuel funnel for automotive use is made of high-quality ABS plastic, which is tough, oil-resistant, high-temperature resistant, corrosion-resistant, scratch-resistant, sturdy, durable, and resistant to breakage or aging, with a long service life
- Practical Functions: This fuel filler gas tank funnel tube helps achieve efficient oil changes in cars. The funnel features a snap-on design on the side to prevent it from falling off during the oil change process, eliminating concerns about oil backflow or spillage and improving work efficiency
- Wide Compatibility: This leak proof change oil funnels neck sleeve is compatible with a wide range of vehicle types, including Ford 2009-2017 Flex, 2009-2016 F150, 2009-2018 Escape, 2010-2017 Taurus and Mustang, 2010-2015 Expedition, 2010-2016 Fusion, and 2010-2014 Explorer; Lincoln 2009-2014 Navigator, 2010-2018 MKT and MKZ, 2015-2018 MKC, and 2016-2018 MKX; Mercury 2008-2010 Mountaineer, 2009-2011 Mariner and Mariner Hybrid, and 2010-2011 Milan. Hybrid
- Replaceable Part Numbers: The OEM parts for this filling funnel tube neck sleeve that can be directly replaced are 8U5A-17B068-EB, 1782177, 1833948, and 2050651. Please check product compatibility, part numbers, and size specifications before purchasing to ensure compatibility with your vehicle
- Product Information: Each pack of ford fuel filler funnels for cars contains 2 pieces. Each piece has a neck length of 6.85 inches, a bottom diameter of 0.7 inches, and a maximum opening size of 1.66 inches. This lightweight, portable, and easy-to-store oil filling funnel is an essential item for everyday driving
- Fits๏ผ For Ford expedition explorer Escape Edge Sport Fusion Focus For Mustang For Lincoln MKT MKZ MKC MKX For Mountaineer Mariner Hybrid For Milan Hybrid
- Applicability: The filter funnel tube for Ford gasoline vehicles with the capless fuel system
- Replace Part Number๏ผ 8U5A17B068AD, 8U5A-17B068-AD 8U5Z17B068A, 8U5Z17B068B, 8U5Z-17B068-B
- Package Included๏ผ Fuel Filler Funnel Tube *2
- Tips๏ผ If you have any other questions, please consult us and we are happy to answer it for you
- ใReference NumberใThe fuel filler funnel directly replaces part numbers13580741(To ensure correct fitment, we strongly advise confirming this part number matches your vehicle's make, model, and year.)
- ใVehicle SuitabilityใCompatible for Chevy Blazer 2019-2022, for Chevy Malibu 2017-2019, for Chevy Silverado 1500 2019-2021, for Chevy Silverado 1500 LD 2019, for Chevy Silverado 2500 HD 2020-2022, for Chevy Silverado 3500 HD 2020-2022, for Chevy Tahoe 2017-2022, for Chevy Traverse 2018-2021, for Buick Enclave 2018-2022, for Buick Encore GX 2020-2022, for Buick Envision 2017-2022 , for Buick LaCrosse 2017-2019, for Buick Regal Sportback 2018-2020.
- ใPremium QualityใHigh-quality rubber๏ผwhich have high reliability, anti-corrosion, wear resistance, sturdy๏ผBuilt to endure the test of time, ensuring long-lasting performance.
- ใDirect ReplacementใOur refueling funnel is designed to make refueling your vehicle easy and effortless. With its innovative design, simply insert it into the fuel tank and enjoy a worry free, clean and tidy refueling experience. Package Includes:1x Fuel Filler Funnel Part.
- ใ12-Month WarrantyใFor any reason, if you are not satisfied with your purchase, please contact us directly.
- Snap-On Design: Our fuel funnel features a unique snap-on design on the side, ensuring stable fixation during fueling or oil changing.The capless funnel effectively prevents the funnel from slipping or shifting,allowing you to enjoy a worry-free fueling experience
- Wide Compatibility: This capless fuel funnel is designed to easily fit the fuel systems of various ford gasoline vehicles,a perfect match.It supports multiple replacement part numbers,including 8U5Z17B068B,8U5Z-17B068-B,8U5A-17B068-AD,8U5Z17B068A,and 8U5A17B068AD.Before purchasing,please make sure that the fuel filler funnel tube replacement part number matches your vehicle model to ensure a perfect fit
- Easy to Use: Simply insert the oil funnel into the fuel tank opening and enjoy a hassle-free experience.The filter funnel tube large opening combined with a smooth inner wall allows liquids to pass quickly and smoothly,significantly improving filling efficiency and saving you a lot of time
- High-Quality and Durable Material: Made from high-quality ABS material,the automotive funnel is robust,durable,and highly resistant to corrosion,ensuring long-term stable use
- Convenient Storage and Portability: The long neck funnel overall Length 6.89" (17.5cm)/Top opening 2.68" (6.8cm)/Bottom opening 0.8" (2.1cm) lightweight design makes it easy to carry and operate without taking up too much space.Car funnel can be easily stored and used whenever needed
This product presentation was made with AAWP plugin.



![Fuel Fill Door Rear Edge Does Not Line Up - 2017-2019 Acura MDX 4 Fuel Filler Caution [Unleaded Fuel Only]](https://static.oemdtc.com/wp-content/uploads/B18-073-03.jpg)







